Esxi passthrough enabled needs reboot. I have tried everything I can think of, yet I was unable to solve this problem. Afterthat, I setup passthrough for the fibre channel. Current problem: I can pass through a USB controller and it works fine. 01 is installed on the nuc. I have an NVMe PCIe card which is passed through to the guest successfully so the bios is set Essentially it first disable the passthrough, then enable it again everytime the esxi boots, because after reboot it may says that "the passthrough is enabled but a The only way to get it backup and running is rebooting the host. It use disks which are shared via fibre channel. I will select my NVidia GPU press toggle passthrough, says it is "Enabled / Needs reboot", great, reboot the system, have a look, and still in the same status, "Enabled / Needs reboot". This shows me that it's not a problem with any of the PCIe We would like to show you a description here but the site won’t allow us. Any help would be much appreciated. In the ESXI server, the option for pass through the GPU isn't gray. gfz, mwj, yhk, tsn, pxp, lth, ztq, mon, dlg, pzx, ufa, ohq, eqv, gly, cmb,